FoldingPack® sliding folding shutter

•    Blind: total protection with absolute visual privacy.
•    Standard micro-perforated: total micro-perforation except for the lower and upper portions for mm 350 each. Safety and visibility.
•    Customized micro-perforated: created with the preferred "blind/perforated" intervals, thanks to the computerized production system that manages the micro-perforation during the element profiling phases.
•    Open: solution with maximum ventilation (70%)
•    Polycarbonate: strong protection and excellent visibility

•    galvanized steel
•    galvanized steel pre-painted in colours: white RAL 9010 – grey RAL 9006
•    aluminium
•    anodized aluminium
•    aluminium pre-painted in white RAL 9010
•    AISI 304 stainless steel
•    powder coating in any RAL colour

•   39x39 mm
•   Visible or recessed

• The folded shutter takes up approximately 12-14 % of the opening
• If you have more space available, we recommend setting aside slightly more space for easier installation and maintenance
• Once we know the measurements and number of curves, we can immediately provide the exact dimensions of the folded shutter; contact us for more information.

• The sliding “run” is about 220 mm deep.
• Each shutter slat complete with fastening accessories is approximately 140 mm wide, but about 220 mm must be left to enable the curtain to turn and swing.

• Any kind of curve can be created in accordance with building regulations.

• The minimum curve radius is 350 mm.

• The minimum arc length with any radius is 550 mm

• A change in radius requires a 100 mm straight section

• Two opposing curves require a 100 mm straight section and a minimum curve radius in relation to the general shutter layout.

• Curve development greater than 5,000 mm requires a 100 mm straight section.

• FoldingPack® does not require a bottom track
• The shutters are secured to the floor with manual locking pins fastened to the curtain and spaced out at approximately 2,000/2,500 mm intervals.
• The bolts are fitted with steel pins that lock into sockets (15 mm diameter) depressed into the floor.
• The stainless steel sockets are topped with dust caps to protect the spring mechanism.

• A compartment can be installed to house and cover the folded shutter.
• These compartments (in sheet metal, plasterboard or wood) can be fitted with a door that completely conceals the shutter once it is folded away.
• Measures 220 mm on the inside.

• The track must be firmly secured to the ceiling.
• The structure must be able to withstand the weight of a fully folded shutter at any point along its entire length.
• FoldingPack® shutters weigh between 6 and 10 kilograms per square metre.

• Vertical support structures may be required depending on requirements